40 Replacement Tens Electrode Pads 2x2 Muscle StimulatorBULK-Healthproo

• 10- Packs of 4 electrode per pack = 40 electrodesReusable Multi-stick GelMolded wire connector for reliability and durabilityFor use with most TENS unit,
• TENS 7000, TENS 3000, TwinsStim, Massager and electrical muscle stimulators
• Directions:Apply only to unbroken skin
• Clean and dry the area to which the TENS Electrodes are to be applied with soap and water prior to application of the Electrode Pads.
• Plug the lead wire into the Pin Connector on the pre-wired electrode pad.To apply to the skin:remove the protective liner from the TENS Electrode and apply to the prescribed location.
• To remove Lift the corner of the electrode pad and peel holding both the back of the TENS Electrode and the edge of the adhesive.
• Replace Pads onto the plastic and replace and seal the plastic bag..
• Note : When removing the pads do not pull from wires ,
• pull off from the corner.
• Pads will last longer if area is cleaned before they are put on.
• Oils and or dirt from the skin cause pads to not to stick
• A small amount of water can help if pads are dry