Electric Blanket Heated Throw, Soft Flannel & Sherpa Heating Blanket Throw with 3 Heating Levels Gray

Before use, please read the user manual carefully

1. When

using an electric blanket, it must be laid flat and placed between the

back of the mat and the bed sheet. It should not be used under a cotton

mattress (it is prohibited to use it with a far red line mattress, self

heating therapy, hand warmers, hot water bags, hot beds, hot water glass

bottles, etc.).

2. Electric

blankets are more suitable for use on hard board beds, and are

prohibited from being used on Simmons beds, wire soft beds, and sofa

beds,

3. The electric blanket should not be folded or folded to prevent heat concentration, excessive temperature, and local overheating.

4.

It is recommended to turn on high-end high-temperature preheating about

20 minutes before going to bed. After going to bed, choose a suitable

temperature and switch gears or turn off the power to fall asleep.

5.

When the electric blanket is powered on, please place the switch at the

head of the bed to avoid squeezing. The switch is prohibited from being

placed under covers, pillows, and other covers, and should not be close

to other heat sources to prevent damage to the controller due to

overheating.

6. The

electric blanket should not be washed with water. If the blanket is

accidentally dirty, it can be laid flat on a flat surface and brushed

clean with a soft brush, or lightly wiped with diluted detergent on the

dirty surface, and then washed with clean water. It should be placed in a

ventilated area for drying, and should not be dried with electricity.

Exposure to sunlight is prohibited.

7. There

is no reason to return or exchange the electric blanket for 7 days,

with a one-year warranty. During the warranty period, the shipping cost

for returning or repairing the blanket to the customer shall be borne by

the merchant, and the customer shall bear the shipping cost and other

expenses incurred by the merchant

8. The electric blanket has an error of 2-3 centimeters, which is an industry rule and does not affect normal use

9. When

users go out or are not in use, they should cut off the power supply

and plug and unplug the power head to eliminate fire hazards.